![]() Still, it is not obvious that the different "model number" be the source of the issue here, but I could not find anything else that could be wrong. I have tried all other 4 P70360 drives and the same issue happens only my first P70360 drive seems to "work" correctly.īut then, when opening the case of all 6 drives, I see that the 5 drives that I am having issue with have the same kind of "model number" written over the dip switches, while the number written on the "good" P70360, the one working correctly, differ from the 5 other drives (see attached pictures, number is on the right of the red part the "good" drive numbe is 0820U 3 1). With this other drive, the motor suddenly halt when only a small torque is beeing applied on the shaft, while when switching back to my previous P70360 the motor runs fine. I happen to have 5 other P70360 drives, and I recently tried another one with another T21 stepper using the same setup as above. I have been using this drive for a while now without problem. ![]() I am using Danaher P70360 drive connected to UMI-7772 and NI 7330 card to control T21NRLC stepper motor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |